Thanks to the high-temperature resistance up to 93 °C, ASA is a great choice for heat-stressed parts. Also, fan-shroud on Original Prusa i3 MK3 is newly made of ASA material.
ASA can find its place on projects, where you need smooth surface similar to a surface treated with car paint. However, this also leads to a loss of small details and rounding of sharp edges.
Thanks to UV stability, ASA is an ideal choice for outdoor use. The material will keep toughness and durability for a long time and will not turn yellow.
ASA can be considered a true successor to ABS. Compared to ABS, it’s UV stable, it doesn’t suffer from shrinking so badly and the fumes produced are much less noticeable. ASA 3D prints are durable, tough and suitable for a wide range of applications. The solidification temperature is also higher compared to PLA and PETG, which gives objects printed from ASA an excellent temperature resistance – there are no signs of deformation up to temperatures near 93 °C. Thanks to all these properties, ASA is especially suitable to print objects meant for long-time outside use.
However, you can still encounter some issues related to shrinking (warping) of the material – especially when printing larger models. Even with the heatbed set to 110°C, the prints can shrink and warp, causing them to detach from the print bed. However, the effects are much less severe compared to ABS. This issue can be eliminated by printing inside an enclosure or by adding a tall skirt around the object.
|Bed||Temperature: 110 ± 5 °C|
Heated Bed Recommended
Skirt or Enclosure Recommended
|Print Surface||PEI sheet|
|Extruder||Temperature: 260 ± 5 °C|
No special hot-end required
|Cooling||Part Cooling Fan Required|
Fan Speed: 30%
For ASA printing, we recommend using the smooth PEI spring steel sheet. With the powder-coated sheet, the adhesion of the material can be too strong, which could potential result in damage to the surface of the sheet. The smooth sheet preparation is easy: simply clean the surface with isopropyl alcohol. To remove the print, wait until it cools down – it will then pop off easily.
ASA is a material that can be easily post-processed. It’s possible to sand the parts using wet or dry sanding methods, smooth them out with acetone vapors, and glue them together with acetone. The result of acetone post-processing will be a very glossy, smooth surface similar to a surface treated with car paint. However, this also leads to a loss of small details and rounding of sharp edges.